Our store is closed on Mondays and Tuesdays, so orders will be shipped starting Wednesday.

For any inquiries, please feel free to contact us via our official LINE account.

Shipping fees are calculated automatically after you add items to your cart and enter your address. Please check there.

FERODO DS1.11 Brake Pads
FERODO DS1.11 Brake Pads
FERODO DS1.11 Brake Pads
FERODO DS1.11 Brake Pads
NO.1
FERODO DS1.11 Brake Pads
NO.3
NO.4

FERODO DS1.11 Brake Pads

Regular price¥49,500
/
Tax included.
Product selection
  • Low stock - 2 items left
  • Inventory on the way

FERODO DS1.11 Brake Pads

DS1.11: Racing pads designed for enhanced control
The DS1.11 brake pads combine the user-friendliness of the popular European DS2500 with the stopping power of the DS3000, making them highly recommended.

They offer not only exceptional bite but also excellent control when releasing the brakes.
These brake pads excel in situations requiring precise braking control.

■ Optimal temperature range: Low temperatures to approximately 800°C
■ Average friction coefficient: 0.72
■ Material: Semi-metallic
■ Intended use: Circuit (racing)

* Not compatible with the S1 Elize.

Brake pad bedding-in procedure
The DS1.11 pads must be bedded in after installation.
Using them without bedding in may cause the pads to chip or crack.

* Purpose of bedding in
Heating the pads to a certain temperature causes the friction material to release a film that coats the rotor. The friction between this rotor coating and the pads achieves the desired bite.

* Bedding-in procedure
Bedding in should be performed at a circuit or another location where safety can be fully ensured.
It is also important to increase the temperature gradually during the bedding-in process. Increasing the temperature too rapidly can cause surface hardening and lead to performance degradation.
Drive 1–2 laps at the circuit using light braking to gradually warm the pads.
Perform at least 15 braking maneuvers from 70% of full speed, applying approximately 50% of maximum pedal pressure for 4 seconds each time.
Next, perform about 15 more braking maneuvers while gradually increasing both speed and pedal pressure.
Drive for a while to cool the brakes.
Return to the pits and inspect the pad surfaces. The process is complete when the entire pad surface shows signs of contact and has hardened.
* Ideally, the pads should reach approximately 500°C during bedding in, and it is not a problem if smoke comes from the pads while they are cooling.
* For the DS1.11 in particular, try to keep the temperature between 500°C and 700°C.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed